@animoose - Got it! Working on a build right now! My issue was that the set screws keeping the gear in place with the shaft weren't tightened whatsoever. Once I tightened those bad boys up, it extrudes perfectly fine now! Thanks so much for the help.by yayforwaffles - Prusa i3 and variants
@animoose - Both the shaft and gear to the extruder rotate just a bit and then stop. I think I need to tune the motor. Where is the potentiometer located? Is it on the actual stepper motor?by yayforwaffles - Prusa i3 and variants
@animoose - Thanks for the tips! Do you recommend any temperature settings I should try? I will remove the extruder and check on the gears. I did notice last time I had it apart that the shaft was spinning almost independent of the gear. I will let you know what happens.by yayforwaffles - Prusa i3 and variants
Hey all! I'm having one MAJOR issue with my printer. Ever since I got this printer a few months ago, I have not been able to get a good print since my first print. The filament will not extrude for some reason. I'm using a 2020 Prusa i3. Any pointers? Some issues that I'm running into are the following - - Filament won't extrude when I command it to do so using Repetier - Filament will not stby yayforwaffles - Prusa i3 and variants