What version of firmware did you load and where did you get it from? The x travel issue is a firmware setting. Most likely the reason it won't move now is that it is setting against the limitby MendingThings - Prusa i3 and variants
So I have been using my F/T 2020 i3 for quite some time now and I don't know why I didn't think of this question before but here it is anyway. Since our height limit is the carriage contacting the motors, which by the way, I have upgraded to the motor extensions, why do we have the hot end mounted so far low below the carriage? If we were to raise it up to just below the carriage, we could gainby MendingThings - Prusa i3 and variants
QuoteDaveA Do you still have the X endstop on the right (max) side of the printer as default from Folger? If you do I don't think auto leveling will work properly. Check out for more information. You may want to update to one of the later Marlin releases. Thanks DaveA, I loaded RC8 last night and got everything working!by MendingThings - Firmware - Marlin
Hi, I have a Folgertech i3 2020, running a ramps 1.4 and Marlin 1.0.2 firmware. I installed a inductive sensor for bed leveling and went through the setup on that and got the probing working fine. However, when it finishes probing it is at the back of the table and when the print starts, it tries to go off the table. It is like it lost its reference to the home position. I am doing a G28 before tby MendingThings - Firmware - Marlin