Hi, Sorry for the late reply, I've tried rebuilding the printer and still have the same problem although I got a single successful calibration cube and now the same thing happens within about 30 seconds of printing. I checked the WATCH_BED_TEMP_PERIOD and it's set to 120 so don't think it's that. Any other ideas anyone?by noelmm - Prusa i3 and variants
I’m having a problem that started a few weeks ago where if I send an M303 E-1 S60 C5 command (or any temp for S) I get the ‘Error:Thermal Runaway, system stopped! Heater_ID: bed’ immediately and the printer halts. My printer, an original Tevo Tarantula hadn't been used or around 6 months and I wanted to start printing with it again. The reason I am trying to PID tune the bed is that sometimes dby noelmm - Prusa i3 and variants
Hi obewan, Thanks for the link, I'll watch that now and see if it helps. Noelby noelmm - Firmware - Marlin
Hi Roxy, Thanks for replying. I thought I had set the bed size in Cura however I'll double check this. Noelby noelmm - Firmware - Marlin
Hi everyone, I was hoping you would be able to help me. I’ve had my Tevo Tarantula for a couple of weeks now and I’ve been calibrating all of the stepper motors so that when I print a 20mm test cube everything is within 0.2mm tolerance which for now is ok for me. What I have noticed is that my prints are not printing in the centre of the bed but are offset to the back right corner. I have tby noelmm - Firmware - Marlin
Hi everyone, I was hoping you would be able to help me. I’ve had my Tevo Tarantula for a couple of weeks now and I’ve been calibrating all of the stepper motors so that when I print a 20mm test cube everything is within 0.2mm tolerance which for now is ok for me. What I have noticed is that my prints are not printing in the centre of the bed but are offset to the back right corner. I haveby noelmm - United Kingdom RepRap User Group