Show all posts by user
http://reprap.org/wiki/Prusa_i3
Re: Endless rebooting at startup (Zonestar 802C) - 5 years ago
I haven´t found any noticable blobs, no... I contacted the support and they will send me another controller board. I hope it helps. Thanks a lot for your time and help!by mkarius - Prusa i3 and variants
Re: Endless rebooting at startup (Zonestar 802C) - 5 years ago
Thanks again for your time! I disconnected the board from the LCD Display. But it doesn´t change anything. So it´s the board you think?by mkarius - Prusa i3 and variants
Re: Endless rebooting at startup (Zonestar 802C) - 5 years ago
Thank you guys for your time. I installed Pronterface on my computer (Windows 10), installed the Silicon Labs Universal Windows Driver until the recognized CP2102 USB to UART Bridge Controller was successfully installed. When I connected the printer via USB the clicking noise stopped and it also stopped rebooting. I tried to connect via Pronteface (COM3, I tried all Baud - Rate Options) and eby mkarius - Prusa i3 and variants
Re: Endless rebooting at startup (Zonestar 802C) - 5 years ago
Thanks a lot for your time. The clicking noise is coming from the board not the power supply. We are at a 220V country (Germany) and it´s correctly set. The firmware was already installed and there´s no SD card in the card- slot. I will install pronterface and connect the printer via USB and let you know what I get. Best regards!by mkarius - Prusa i3 and variants
Endless rebooting at startup (Zonestar 802C) - 5 years ago
Hi guys, my son saved some money over a while and bought a 3d Printer at gearbest, it´s a Zonestar 802C. After building it up and going through some issues we are stucked: If we power on the machine, the display starts and shows information about model, firmware, etc., but after 2-3 seconds the display refreshes showing the same info again and again. It seems that it´s rebooting all the time.by mkarius - Prusa i3 and variants