Show all posts by user
http://reprap.org/wiki/Prusa_i3
Page 2 of 2 Pages: 
12
Results 31 — 34 of 34
12
Re: Migbot Prusa i3 Unofficial Support Thread - 10 years ago
Quotekaffemustasj QuoteCrackinX Quotekaffemustasj QuoteCrackinX Quotegwc2795 QuoteCrackinX I'm having an issue as well with my Auto leveling in almost the same way as above, I have my sensor hooked to 12V and a V divider so the signal wire outputs about 4.5V, it is Normally closed so outputs 4.5V when NOT triggered. I have the endstop inverted in the firmware pullup disabled and all that. My issuby CrackinX - Prusa i3 and variants
Re: Migbot Prusa i3 Unofficial Support Thread - 10 years ago
Quotekaffemustasj QuoteCrackinX Quotegwc2795 QuoteCrackinX I'm having an issue as well with my Auto leveling in almost the same way as above, I have my sensor hooked to 12V and a V divider so the signal wire outputs about 4.5V, it is Normally closed so outputs 4.5V when NOT triggered. I have the endstop inverted in the firmware pullup disabled and all that. My issue is that when hooked up does noby CrackinX - Prusa i3 and variants
Re: Migbot Prusa i3 Unofficial Support Thread - 10 years ago
Quotegwc2795 QuoteCrackinX I'm having an issue as well with my Auto leveling in almost the same way as above, I have my sensor hooked to 12V and a V divider so the signal wire outputs about 4.5V, it is Normally closed so outputs 4.5V when NOT triggered. I have the endstop inverted in the firmware pullup disabled and all that. My issue is that when hooked up does nothing triggered or not it alwaysby CrackinX - Prusa i3 and variants
Re: Migbot Prusa i3 Unofficial Support Thread - 10 years ago
I'm having an issue as well with my Auto leveling in almost the same way as above, I have my sensor hooked to 12V and a V divider so the signal wire outputs about 4.5V, it is Normally closed so outputs 4.5V when NOT triggered. I have the endstop inverted in the firmware pullup disabled and all that. My issue is that when hooked up does nothing triggered or not it always reads as open. Power is hoby CrackinX - Prusa i3 and variants
Page 2 of 2 Pages: 12
12