QuoteWes78 QuoteAccidentalWisdom QuoteWes78 well what you do is..... watch this. it helped me ALOT! if you have auto-lvl watch this one too Tom has good videos... watch them ....ALL... Thanks, Wes78, I will try this out tonight! I got a little closer with my own methods last night but hopefully this video will help me finalize it. The auto-leveler video is interesting, I need to get onby AccidentalWisdom - Prusa i3 and variants
QuoteWes78 well what you do is..... watch this. it helped me ALOT! if you have auto-lvl watch this one too Tom has good videos... watch them ....ALL... Thanks, Wes78, I will try this out tonight! I got a little closer with my own methods last night but hopefully this video will help me finalize it. The auto-leveler video is interesting, I need to get one of those sometime soon! I willby AccidentalWisdom - Prusa i3 and variants
QuotePutzer AccidentalWisdom What version of Windows? Had trouble installing on Win 10. Am using on Win 7. Win 10 has driver install issues. There is a work around but am too lazy to do it. Hey, Putzer, I am on Windows 7, but all set now with that problem, thanks! Ax and all, sorry, I meant to come back with an update. I figured it out with everyone's help.. The updated driver is good (thanks,by AccidentalWisdom - Prusa i3 and variants
QuoteAx Bit of research regarding the Windows Driver, you can get the latest drivers from here You can try that as it will probably be more up to date. If that doesn't work, try this one. Tbh having both won't hurt. I don't run Windows, I'm a Linux user and all this works out of the box but the above should work. So I tried both the VCP and the D2XX drivers from FTDIchip. In both cases the driby AccidentalWisdom - Prusa i3 and variants
QuoteSort of, you have them plugged into the wrong ports on the board, make sure they're plugged into the minus X and minus Y, I have a feeling you've plugged them into the positive X and Y.. Sorry wasn't concentrating much above, no firmware jigging needed,. So I just checked and the problem was that the X and Y Limit Switch plugs were reversed - X was in Y and Y was in X. I had checked only thby AccidentalWisdom - Prusa i3 and variants
QuoteSort of, you have them plugged into the wrong ports on the board, make sure they're plugged into the minus X and minus Y, I have a feeling you've plugged them into the positive X and Y.. Sorry wasn't concentrating much above, no firmware jigging needed,. Entirely possible, haha. I will check that when I get home tonight. Thanks for your help, I will post back either way in 4 hours or so. Aby AccidentalWisdom - Prusa i3 and variants
QuoteAx Can't help with tge Windows issue, but seems the polarity fir the steppers is wrong, hence when homing it goes the wrong way. Either turn the plugs the other way or change the firmware. I'll get you the exact bit to change when I get home. Thank you for the reaponse, AX. Do you mean that you think I might have the Y Stepper cable plugged into the X slot and the X Stepper cable plugged inby AccidentalWisdom - Prusa i3 and variants
Greetings! So I just put a Migbot Prusa i3 together. Had some issues getting the driver to install, still not certain that it is installed correctly. Below are my two problems (so far): 1. Cura (v15.04.4) cannot find the printer. I tried using the Bed levelling Wizard in Cura, but it fails to establish connection to the printer. The FT232R USB UART device shows in the "Unspecified" section of mby AccidentalWisdom - Prusa i3 and variants