Thanks for your help.I'll leave the paper in place. Thanks, Mark.by Springfield-Jack - For Sale
The black paper under the glass works. Is there any reason why the behavior should have changed ?There is one other Bigbox user who is having similar problems where his sensor only triggers on parts of the bed!by Springfield-Jack - For Sale
Hello David, I have a E3D Bigbox printer using one of your sensors which for reasons that baffle me has stopped responding!It triggers with pretty nearly everything I try: clear plastic, black paper, even a mirror but it refuses to trigger with the glass and bed though either of those on their own will make it trigger!I've spent nearly 3 days fiddling without any success.Hopeby Springfield-Jack - For Sale
Quotesneaky_print1. The extruder power connector (black, plastic, female, six pins) does not seem to fit the the connector (black, plastic, male) for the Duet board. The male connector has about another 3 - 4 mm to go before it snaps in place and using a significant amount force (I tried putting it in a vice) does not help. Sounds like you did what I did-carefully followed the diagrams when a goby Springfield-Jack - Fisher
I realised that my warning wasn't particularly helpful so I'll try again: Looking from the front, the cable hole in the base plate should be on the left, at the base of the notched pillar. Another thing that caught me out-would have been obvious had I done a test fit.....I didn't! The catch--the little black thing in the diagram-- is at the front and the wires should be inserted from theby Springfield-Jack - Fisher
Also received my Fisher Delta kit yesterday afternoon and also experienced difficulties with the end stops-though it was my fault for miss-reading the screw size! I also placed the bottom plate upside-down!-The instruction: Quote"Slide the base plate along the bars to each motor assembly in turn. Start with the side nearest the rectangular slot to ensure the base plate is correctly orientated.by Springfield-Jack - Fisher