Hi all: I have reprinted a dimensional adjusted effector to return to the original Fisher arms axis of rotation and reestablish arms parallelism. Now works better. I have reduced an error of 2mm to less than 0.5mm. Thank you very for your help janpenguin. Regards.by SEUTec - Fisher
Hi: I have tested 4 points test and I don't get enough good autoleveling. I need to test 7 points to get a good autolevel. But I don't have parallel arms. I will correct this and see what happens. I have a difference of 4.2 mm from effector to carriage. I have changed a lot of pieces in my Fisher and this may the problem. Thank you very much, for your help. Regards.by SEUTec - Fisher
Hi all: I am getting non squared cube while X Y scale calibration test for an 80x80x2 mm cube. See attached fig. For M579 X1.00 Y1.00 Z1.00 I can adjust X Y scales by M579 X1.066 Y1.074 Z0.98 But the vertical lines remains unparallel. How can I solve this ? This is a Firmware Bug ? Regards.by SEUTec - Fisher
Hi all: I want to share two effector mounting alternatives. See pictures. Regards.by SEUTec - Fisher
12V Voltage Regulator (7812) for the fans connected in the Duet power input.by SEUTec - Fisher
Well. The fans in the pictures are 12V, for idea test. But I will install the Huxley 19V fan from RepRapPro when I have it. And connect it directly to the 19V power supply without 12V regulator. Regards.by SEUTec - Fisher
Dimensions: 40x40mm Voltage: 19 Vdc. Connected direct to the 19V power supply.by SEUTec - Fisher
Hi all: I want to share an idea for cooling the Duet board and axis motors by installing fans in the RepRapPro logo holes. Regards. Sebas sje@tinet.orgby SEUTec - Fisher