I would love to have a 300mm x 300mm heated bed.... what/where can it be found? jack@heritagesonline.com would plan to build a larger 3D printer.....I've built 2 Prusa3 models & want get larger, to print a helicopter....by JacktheKnife47 - New Zealand RepRap User Group
I built a Prusa i3 type printer, am using Repetier-Host & Slic3r ver: 0.9.10b . I must have some setting incorrect. For example, printing XYZ-Circle_Cal_-_90mm the printer will do a great job laying down most of the first layer, then when it goes to cross over a previously printed area the print head hits it & bounces up & down. Then the Printer is off center. What am I doing wroby JacktheKnife47 - Slic3r
Help, I'm a Rookie!... Built this Printer from Prusa i3 design, Added Arduino & Ramps 1.4, I have Arduino addressing thru COM3, but when I load Pronterface (with the same COM & Baud Rate) it says cannot open COM 3... "Frustrated in South Jersey"by JacktheKnife47 - General
Ok, seems I was too hasty in asking 4 help..... one of my 12V wires to the ramps was just a little loose... Duh! Now, however, after a print, no heat & no motors again.... all wires are tight. I'm getting power to the two inputs, & get 0 reading on the heater outputs???? Help Please!by JacktheKnife47 - Reprappers
I built a Prusa i3. Arduino 2560 with RepRap Ramps 1.4. & using Windows XP. I load Pronterface ( using Slic3r) & was successful with my 1st print. Now I go back to access the printer & I cannot get the motors to work or the extruder temp. I have rebooted my computer, unplugged USB, etc. & once I hand moved the Y axis to it's Endstop, then the motors were available again. So I madeby JacktheKnife47 - Reprappers