It worked! Thanks!by drdray1 - Firmware - Marlin
I am having the same issue and am going to try your solution in the morning. Thanks for asking questions!by drdray1 - Firmware - Marlin
Hi Olaf thanks for the input, I replaced my start GCode which was standard start Gcode for slic3r and the 15 didnt do anything so I changed it to -8.5 and at the end of homing the z axis it would lower to -8.5 but would immediately raise back up to the height it shows in the video and begin printing. Any ideas? -Draytonby drdray1 - Reprappers
Hi guys, I'm having an issue where my auto bed leveling is executed just fine but when I go to print it heats up and everything but then starts printing in mid air. Any ideas? Help is appreciated!! Thank you! Here is the video of the printer in action of failure Video Of The Problem Here is a slideshow of my Settings in Marlin Pictures of the settingsby drdray1 - Reprappers
Meaning the Arduino its self?by drdray1 - Reprappers
ok just tried that and it doesnt seem to be the issueby drdray1 - Reprappers
Hey guys Ive a Prusa i3 and have printed a few things with it already but now the x axis wont move when told to do so. When i plug it into the y axis spot it works fine. Any ideas? Im using repetier software and marlin firmware Thanks!by drdray1 - Reprappers
Hey i just built my prusa i3 and have printed a few things from it already. In transporting it at the new location the x axis and extruder dont function. Ive already tested the motors and stepper sticks and those work fine. Im using repetier and marlin. I think its in the software or firmware, any ideas? Thanks in advance! P.S. I may be totally wrong about the firmware and software.by drdray1 - Reprappers
HI I have a prusa i3 and i have printed a couple objects that turned out ok. So i decided to calibrate the machine better. Once i was done with this calibration my extruder stepper motor would output the correct amount of filament but now it does it extremely slowly. Ive checked to make sure the motor isnt fryed which its not, it IS getting the correct voltages, not to much or to little, and nothby drdray1 - Reprappers
Perfect! Thank you a ton! I really appreciate it! It printed the cube successfully! The z axis steps per mm like you said in the firmware were wrong and ive got the correct numbers in there now! Thanks Againby drdray1 - Reprappers
Ok ive calibrated everything but the extruder (i am about to do that) and the z axis goes up 1 mm when i tell it to do 10mm. can you help me fix that? y and x axis work fine 100mm=100mm. Layer heigh is .3 mmby drdray1 - Reprappers
Hi I just finished building a prusa i3 from replikeo and have been trying to get a successful first print but when i start the printing of a cube it doesn't raise the extruder up to the second layer or the third. it drags it through the first layer and pulls it off of the bed. Any idea? Using the manual z axis movement buttons i can raise and lower and home it just fine but once the print startsby drdray1 - Reprappers