THanks Dustby onearmpilot - Firmware - Marlin
Can't set BLTouch probe offset in Marlin TH3D V1.R2.10d When I go into Control -> motion -> probe z offset the maximum negative value I'm allowed to input is -4.975 but this still leave the print nozzle approximately 8mm from the bed. Does anyone know what's going on? Why can't I set the probe z offset? Everything else with the BLTouch installation is working. I'm not sure this is the cby onearmpilot - Firmware - Marlin
Thanks Frans@France that looks interestingby onearmpilot - RAMPS Electronics
Thanks for all the help Dustby onearmpilot - RAMPS Electronics
Thanks Dust, thats great, just what I needed I take it I don't use the jumpers to set the micro stepping on the ramps 1.4 board? Thanks againby onearmpilot - RAMPS Electronics
Hi Dust Thanks for the reply, any chance you can explain in a bit more detail? i.e.if I ground the pololu module (how do I do that?) do I simply connect the stepper output of the ramps board to the stepper input of the suggested motor driver controller? As you can probably guess, I have no idea how to do what you recommended, any diagrams would be great or an idiots guide. Thanks againby onearmpilot - RAMPS Electronics
Hi everyone, I'm building my first 3D DLP printer (3D SLA printer). I have my ardunino mega board, ramps 1.4 with DRV8825 driver modules. The specifications of the ramps 1.4 board say 12 volts at 11amps or 12 volts at 5amps, however I want to use a nema 34 the required voltage is 24-60V 5.5amps current/phase. Can anyone help me with connecting this up, any diagrams or tutorials would be great buby onearmpilot - RAMPS Electronics
Hi All I'm building a dlp sla 3d printer, can anyone tell me the best or even a good slicer frontend software solution also are there any diy uv activated resin recipes? I guess these questions have been asked a million times but I'm a newbie and would appreciate some guidance. Thanks in advance Steveby onearmpilot - Polymer Working Group