Hi, I've just replaced the motherboard in my Tripodmaker Black with an SKR V1.3 and finally have it printing. I have the delta printer height set correctly, my diagonal rod length is correct and my steps per rotation is also correct. When printing a 20mm calibration cube though, the X and Y are 19.1mm but the height is only 16.6mm. When I auto calibrate the printer, it returns the correct height;by mattrose85 - Printing
I'm replacing an original board in a Tripodmaker Black with an SKR 1.3 and I'm going through adding things step by step and have hit a wall. As soon as I enable thermistors in config to a real value, i.e. changing #define TEMP_SENSOR_0 from 998 to 147 the board refuses to start and the TFT controller can't connect. If I change the config value back to 998 (as in setting both #define TEMP_SENSOR_0by mattrose85 - Firmware - Marlin