A guy on the flite test forms was able to help me out and I am using his arduino code now. Thanks for the help anyway!!!by rcflyer729 - Firmware - mainstream and related support
I have already done all of that. Also I am not using a servo I am using one of these. This is the code that I have set for the bed leveling. #define ENABLE_AUTO_BED_LEVELING // Delete the comment to enable (remove // at the start of the line) #define Z_PROBE_REPEATABILITY_TEST // If not commented out, Z-Probe Repeatability test will be included if Auto Bed Leveling is Enabled. #ifdef ENABLE_AUby rcflyer729 - Firmware - Marlin
Can you give more some more detailed information on that. I don't quite understand what you said to do. Thanks for your help!by rcflyer729 - Firmware - Marlin
HI all I need some help. I am trying to setup auto leveling on my folgertech Pruss I3 2020. I bought a sheet a aluminum and a sensor. I installed everything and test the sensor. Everything was working fine so I went to update my marlin. Fortunately someone had already done this so I did not have to go do it myself. I flowed the video below to set all my settings. When I send a G28 the printer levby rcflyer729 - Firmware - Marlin
Hi I have the folger tech prusa I3 and I am getting some wavy lines in my prints. I have read that other people switched to cura so last night I tried it. I was wondering if anyone has some setitng they can share with more for using cura with this printer. Also when I hit usb print in cura the little that that alows me to move the axises and change the heat does not come up. The only thing that cby rcflyer729 - Prusa i3 and variants