Thanks for your feedback Roxy! I appreciate it. As of right now I just wrote a gcode that will move to the 9 mesh points and allow me to home manually but I'm going to keep at this Marlin solution. What really confuses me is that even if I download the Ultimaker2Marlin config.h from GitHub it still doesn't work. Maybe I need to play around with the wiring.by psiewert - Firmware - Marlin
Not entirely sure what you mean, but I think you're asking if there is a way to have both the CNC logic and 3D printer logic on the same Ramps 1.4 board and switch between the two? It really depends on what exactly the differences are but wouldn't it just be easier to re-flash the controller with the firmware when you go back and forth?by psiewert - Firmware - experimental, borrowed, and future
So I recently built an UltiMaker 2 Go clone with Marlin 1.1 RC3 and everything is working pretty great. I wanted to do manual bed leveling for the time being but I'm running into an issue. The only end stop I have for the Z axis is at the MAX distance. On this printer the bed raises up to the hot end before printing. The Z_MAX_POS is set to 107 and the Z_MIN_POS is 0. When I home the printer thby psiewert - Firmware - Marlin