Show all posts by user
Everything about Marlin firmware : Discussions, questions, support and feature requests...
Re: Einsy + BLTouch? compilation issues.. - 7 years ago
Did you figure it out? I'm installing my Einsy and came across the same issueby kendler - Firmware - Marlin
Re: Noise from Y motor on CoreXY - 8 years ago
Good idea. I've tried. same story - Y motor is noisyby kendler - RAMPS Electronics
Noise from Y motor on CoreXY - 8 years ago
I've built a CoreXY printer (HyperCube) a few months ago Not sure why, I've always had a very loud noise when moving, caused by the Y motor vibrating and thus vibrating the entire frame I've tested a different Motor/Drive/RAMPs board - result is the same. motor is vibrating (can feel it when the motor is in my hand) Same with Marlin 1.1.4/5/6 Any ideas what can be the cause of that?by kendler - RAMPS Electronics
Re: LM8UU bearing mount for aluminum plate - 10 years ago
it seems to be 1.250inch appart (end to end - or 1.075 center to center)by kendler - Prusa i3 and variants
LM8UU bearing mount for aluminum plate - 10 years ago
Hi, I'm building a new printer I've bought this aluminum plate but sadly, I couldn't find any LM8UU bearing mount that fits the holes before I go and design a fitted bearing mount or drill new holes - did anyone have a design fitting this plate?by kendler - Prusa i3 and variants