I am getting build up on small areas of a solid infill. When the path is longer than about 6-7mm, the infill is correct. However, if the path is less than ~6mm, then it seems to be over extruding or building up in that area. What might cause this? Is this a jerk setting for the extruder? Is this a retract setting? I apologize if this has been asked and answered before. I cannot find any informatby Beengie - Printing
Thanks for the help. It looks like I had my DEFAULT_MAX_FEEDRATE too low.by Beengie - Firmware - Marlin
I am using G29 V4 to see what is going on since the G29 didn't seem to be working. It returns a bed matrix of 0.0 across the board. Is there a setting I'm missing in the firmware to correct this?by Beengie - Firmware - Marlin
I am currently having issues with my z-axis. I am unable to perform both a G28Z command and a G0Zxxx command. My steppers (two steppers for z with 8mm acme screws) just buzz briefly then stop. It sounds like there is not enough current to drive them. However, I am able to move the axis both up and down using the manual controls inside of a program such as pronterface or repetier. This is a branby Beengie - Firmware - Marlin