Hi Dust Enclosed the Gcode of raft layers where the problem starts. It does the first layer and then goes to the back and completly get the filament out. I checked that already and could not find anything wrong. Pls check it and give me feedback Thanks and regards Sacramentoby Sacramento - Firmware - Marlin
Hi Gaz3 and Geball I had the same problem and solved it by going to config adv and changed the following settings: #define WATCH_TEMP_PERIOD 40 //seconds #define WATCH_TEMP_INCREASE 4 //ºC #define WATCH_BED_TEMP_PERIOD 90 //seconds #define WATCH_BED_TEMP_INCREASE 2 //ºC If you increase WATCH_TEMP_PERIOD by 50 or 60% your problem is fixed and if not decreby Sacramento - Firmware - Marlin
Hi everybody I'm having a problem with Marlin 1.1.9. I start printing and everything goes ok, but after the first layer extruder goes to the back of the printer and takes out all the filament and then noozle and bed temperatura goes down and cannot continuing print. I would like some help on this as I cannot fix the problem. Thanks in advance Sacramentoby Sacramento - Firmware - Marlin
Robert thanks for your answer. Nevertheless if I change the status to true it simple do not start pre print procedures. I saw your answer to another where you say you connected the filament runout to X Max and did some changes on the firmware like that: Pins.Ramps.h //#ifndef X_MAX_PIN //#define X_MAX_PIN 2 // This is my X-Max pin, you should yours //#endif // define X_MAX_PIN 2 for the filameby Sacramento - Firmware - Marlin
Hi everybody When I start a printing job the printer after heating goes to a point and wait for the filament to be exchanged and it stays at "Print paused". After filament is chaged and extruded I do "Print resume" and it restart the same procedure, that is goes to the inicial point and wait for the filament be exchaged. Can someone help me? What is the problem? is it a bug of Marlin 1.1.8?by Sacramento - Firmware - Marlin
Hi everybody I built my own 3d printer and I am using marlin 1.1.8 firmware. I cannot put BL Touch 3D working, as well as endstops. Also I got error when triyng to warmup bed to 110º to print with ABS. I use Ramps 1.4 and two extruders with a single nozzle. I attached my config file Can someone help me? Thanks Sacramentoby Sacramento - Firmware - Marlin
I have an error message when compiling Marlin 1.1.x that is "static assertion failed: DEFAULT_AXIS_STEPS_PER_UNIT has too many elements." Attached is my config file. I have two extruders with one hotend. Pls help me and what I am doing wrong Thanks Sacramentoby Sacramento - Firmware - Marlin
Hi I build my own 3d printer using ramps 1.4. I am now trying to upload Marlin firmware but when I try to compile it I allways get a compile error. I use last Arduino IDE and las version of Marlin Attached is the error file Pls someone help me to solve this problem. I reinstall Arduino IDE and put Marlin on C: root Thanks Sacramentoby Sacramento - Firmware - Marlin