Thanks Dust. The thermistor is still attached to the to the center of the bed tightly held by the original tape. I had to pull up the thermal blanket to see this but everything got re-adhered quite well. Regarding the bed wires being too thin, they are the original that came on/with the machine. I will check the integrity of the wires from the board to the bed.by BearcatTD - Firmware - Marlin
What is the problem? Trying to print on my CR10v2 and SKR 1.4 Turbo. I have the bed temp set at 65, but it heats up to 55 and just stays there. Eventually I get this error: “Your printer’s firmware reported an error. Due to that OctoPrint will disconnect. Reported error: Heating failed, system stopped! Heater_ID: bed - Printer halted. kill() called!” What did you already try to solve it? I did aby BearcatTD - Firmware - Marlin
Hello, I am wanting to flash Marlin 1.1.9 to my Ender 3 which has the new 1.1.5 control board, but I cannot find a definition in the "boards.h" file. Any help would be appreciated. Thanks, Patby BearcatTD - Firmware - Marlin
I am running Ender 3, MKS GEN L, BLTouch and bugfix1.1. I have gone through all of the X gantry leveling (it is level to within .23mm), Z level...everything is level to everything else. I run G28...works great. I run G29 and it does the first five spots perfect (3x3 grid) but on 6 (middle left), the probe doesn't deploy. I am pulling my hair out on this one. are there any adjustments I can make iby BearcatTD - Firmware - Marlin