Hello, I start to print something then I pause it and after I resume it is too close to printed model how can I increase z after resume? I tried to increase #define POWER_LOSS_MIN_Z_CHANGE 0.05 //#define POWER_LOSS_ZRAISE 2 (I do not have ups) but none of them work. any suggestions? Thanks,by Burak - Firmware - Marlin
I updated line to this #define POWER_LOSS_RECOVERY #if ENABLED(POWER_LOSS_RECOVERY) #define PLR_ENABLED_DEFAULT true // Power Loss Recovery enabled by default. (Set with 'M413 Sn' & M500) //#define BACKUP_POWER_SUPPLY // Backup power / UPS to move the steppers on power loss //#define POWER_LOSS_ZRAISE 2 // (mm) Z axis raise on resume (on power loss with UPS)by Burak - Firmware - Marlin
Hello, I pause the print then turn off and wait a while and turn it on again however there is not resume print. I defined POWER_LOSS_RECOVERY but it does not work and I am sure power loss recovery is enabled while printing how can I fix it? my printer is ender 3 pro with skr mini v2 and bltouch Thanks,by Burak - Firmware - Marlin
Hello, No problem is not it is not editable I can edit it but it is not as functonal like th3d it does not do it while printing or it do not change z level in real time when I edit valueby Burak - Firmware - Marlin
Hello, With my old mainboard I was using Th3d software but I changed my mainboard and have to use marlin but with th3d software I could configure zlevel offset realtime (where z level moves when I edit value instantly) but when I start to use marlin it does not work like it . Does marlin have this kind of feature? Thanks,by Burak - Firmware - Marlin