I also wonder where to change that value of 45 ? I feel like that that value is very dependent on the X_MIN_POS / Y_MIN_POS and the nozzle probe offsets, but I don't want to change my min_pos and offsets anymore as I just calibrated it together with Cura to "properly" print the max volume of my Ender 5 Plus of 350x350x400. Marlin's default firmware values for the Ender 5 plus is way off and won'by jtrner - Firmware - Marlin
Hi, Did you manage to resolve the bed leveling corners issue? I'm having the same problem. I enabled the LEVEL_BED_CORNERS definition but whatever values I assigned on LEVEL_CORNERS_INSET_LFRB {n, n, n, n} doesn't do any changes at all. I expect that those 4 values of LFRB are the offsets for the Left, Front, Right and Back edges of the bed. This is not so intuitive at all.. The 4 cornersby jtrner - Firmware - Marlin
TMC2209 driver's busted. I swap the driver from the different axis and the extruder starts working. Good thing I ordered the 6 TMC2009s bundle in Aliexpress. Its weird because the M122 status says the driver is OK and connection is established. The debug logging looks normal too.by jtrner - Firmware - Marlin
QuoteMMcLure OK - the most probable issue is a problem with the driver enable signal. You don't happen to have SOFTWARE_DRIVER_ENABLE turned on? That is known to cause problems and should only be turned on if the hardware does not have a physical enable pin for the drivers, which is definitely not the case for an SKR 1.4. What would be the next thing to look for? SOFTWARE_DRIVER_ENABLE is alreadby jtrner - Firmware - Marlin