I setup Marlin with X, Y & Z axis, when I home the machine it homes properly, but in case I move the any axis before homing it does not stop on Endstop trigger. Please note that while homing the machine it takes help from end stops and stops when reaches at end. I can see end stop LED shows up, but motors keep moving, is there some configuration I need to update?by sairfan1 - Firmware - Marlin
did you mean ? #define MANUAL_X_HOME_POS 0 Because i was not able to find below in configuration.h #define X_HOME_POS 0by sairfan1 - Firmware - Marlin
That makes sense, but thing that makes me concerned is that when it hits the switch it must be stopped no matter where it is or what or the X & Y at that time What I understand purpose of switches is to not let it go out of the boundariesby sairfan1 - Firmware - Marlin
I'm setting up Marlin with 5 Axis, I did not change anything in configurations files except that configurations related to enabling 5 Axis. When I move any of X, Y or Z Axis for the first time(by first time I mean first movement of any axis after turning ON the machine) it moves toward positive number for a some distance (it's not the distance that was sent in the parameter), but when I move itby sairfan1 - Firmware - Marlin
Thanks, just looking for a quick tip, as I'm using RAMPS board how will I refer to a I/O pin For example D8 on the board, can i refer in command like M42 P8by sairfan1 - Developers
I recently bought RAMPS 1.6 board, I downloaded and installed latest Marline 2.x firmware, Before installing firmware I configured it for 5 Axes, as I'm not using it for 3D printer so i set Extruder to Zero. I double checked board for marlin is selected RAMPS I want to turn ON/OFF D8, D9 and D10 when i send command M42 along with parameters it says unknown command, can someone help me how canby sairfan1 - Developers