Adjusting Z_PROBE_LOW_POINT did not help. I got the mesh probe to work by changing Z_MAX_POS from 215 to 210. This is a PULSE XE from MATTERHACKERS and they have a different way of doing the Z axis. They home to max z( #define Z_MAX_POS 215); there is a proximeter at Z MAX that homes the nozzle to Z=215.(This is build plate dimension that MATTERHACKES advertises) I modified the PULSE XE to a diby williamlynn - Firmware - Marlin
I was thinking the same thing so I changed Z_PROBE_LOW_POINT from -5 to -8 but the same thing happened. Attached is video of the error occurring. For information the PEI bed plate is .891mm thick and the GLASS plate is 4.678mm Z_PROBE_LOW_POINT is -5 Z_OFFSET is -3.25 The glass plate is 3.787 mm thicker so if I understand the Z_PROBE_LOW_POINT correctly then -8mm should be enough the makeup forby williamlynn - Firmware - Marlin
I have a PULSE XE printer with BLTOUCH using UBL. The BUILD MESH works fine using a PEI BED(MAGNETIC) with z offset at -3.3; the bed mesh is an average of +3.9xx. When I change the bed plate to a glass bed I get an error: QUOTE Probing mesh point 1/100. Errorrobing Failed Errorrobing Failed Probing mesh point 2/100. Error:!! STOP called because of BLTouch error - restart with M999 Error:!! STOPby williamlynn - Firmware - Marlin
That fixed it Thanks again Billby williamlynn - Firmware - Marlin
#define TEMP_STAT_LEDS are NOT enables anywhereby williamlynn - Firmware - Marlin
The code compiles and builds fine but the screen is blank when I download the firmware to PULSE printer. I have checked everything I can think of with no success. The only thing I see that is suspicious is that your code used EXP_05_PIN for LCD_RESET_PIN #define LCD_RESET_PIN EXP1_05_PIN and STAT_LED_BLUE_PIN #define STAT_LED_BLUE_PIN EXP1_05_PIN // PF5 EXP1_03_PIN is also used iby williamlynn - Firmware - Marlin
That worked. Thank you, you saved me a lot of work and I don't think I would ever come up with that solution. Billby williamlynn - Firmware - Marlin
Thanks for input The board in the PULSE XL is a EINSY_RAMBO and the LCD is a FYSETC_MINI_12864_2_1 In Configeration.h I have selected the EINSY_RAMBO and the FYSETC_MINI_12864_2_1 as follows: // Choose the name from boards.h that matches your setup #ifndef MOTHERBOARD #define MOTHERBOARD BOARD_EINSY_RAMBO #endif Configuration.h LINES 26-29 #define MachineType "E" #define ExtruderType 4 // 1 =by williamlynn - Firmware - Marlin
I am trying to configure the MATTERHACKERS PULSE XL firmware located at the following site: The source code does not compile and I have found most of the bugs except one. It will not compile when using the MINI 12864 or RepRapLCD panel. It will compile with the VICKY2 panel. The error code I get is: Marlin\src\lcd\dogm\ultralcd_DOGM.h:211:23: error: 'DOGLCD_CS' was not declared in this scope Mby williamlynn - Firmware - Marlin