Holy crap, thank you for posting this! I was two minutes from wiring my motors in parallel to try and figure it out. I'd say 4000 steps/mm was a bit high. 400 working much nicer.by Gurry87 - Duet
This was exactly the answer that I was hoping for. So I'd say that the C model just essentially includes the Bowden extruder. All of it for naught, however, as I ended up going with the Anet A6. I do thank you, though, for answering this question. I'll file this one away in the memory banks for future reference.by Gurry87 - Prusa i3 and variants
I figured that would be the case, but the model I'm looking at lists as an 802C. Every bit of support I'm finding online is listed under other variants. As I said, just checking if there are any finer differences than just a letter.by Gurry87 - Prusa i3 and variants
Hey all Looking to purchase my first printer, and I've essentially narrowed down which model I'm looking for, however I'm just not sure of the differences between these models; P802C, P802M, P802N, P802Q. Anyone able to give a little bit of insight into this? Thanks!by Gurry87 - Prusa i3 and variants