I thought about that, too. But I checked the wiring and there is no short circuit, and the connectors are properly placed on the board. Although difficult I think the thermistor is defective. And thank you for your help.by MARCENEIRO JOVEM - Duet
And message erro :Heater 1 fault: monitor 0 was triggered[by MARCENEIRO JOVEM - Duet
I need a little help from my friends. I'm riding a Voron 2 using RevoVoron hotend, Duet2 wifi and RepRap Firmware. The RevoVoron sensor is connected in E0 Thermistor 1 and the Heater is connected in E0 Heater. It happens that the temperature is at 600 degrees Celcius. Config.g is like this. Where am I going wrong? ; Heaters M308 S0 P"bedtemp" Y"thermistor" T100000 B3950by MARCENEIRO JOVEM - Duet