For me problem seems to be solved: there was bad heated bed. i swap heated bed from another printer (exactly the same) and it works just fine. woo-hooby AlexNZ - RAMPS Electronics
Here is what i got on fuses: looks like top one is 11 and bottom is 5 amp...by AlexNZ - RAMPS Electronics
I measured voltage on a PTC fuse - it is 0.15V and i don't understand why green led on heated bed not litby AlexNZ - RAMPS Electronics
Hello! seems that i have the same issue here recently i finished assembly my delta-Mendel printer and when i turn printer on and tell prointerface to print, or heat bed to 110° it start to heat bed, but when thermistor shows about 40° - voltage on D8 goes from 12V to 0 resulting in heated bed stops heating (it goes by inertia up to 60° but without power at the moment). No green light at heatedby AlexNZ - RAMPS Electronics
Да я сообразил уже что у меня 34 стояла, спасибо! все заработало правда походу оно теперь застужает hotend нещадно (с 230 опускает до 170) где можно почитать про то как правильно печатать с вентилятором?by AlexNZ - Russia RepRap User Group
при печати ABS - ABS Juice - вам поможет берете ацетон (с полстакана) , немного обрезков ABS-пластика (из расчета 1.75 пруток - сантиметров 30) наливаем ацетон в банку с герметичной крышкой, которая удержит испарение ацетона (а испаряется он отлично, проще всего взять другую банку из под ацетона) нарезаем туда пластик кусочками, даем раствориться (само растворяется за сутки) но если взбалтывать -by AlexNZ - Russia RepRap User Group
Привет парни, у меня похожая но другая беда - вентилятор рабочий (если цеплять напрямую к БП на 12 - все крутится) но я не могу подать питание на D9 - команды M106 / M106 Sxxx ничего не делают и на D9 питания нет. В чем может быть дело? RAMPS 1.4, Marlinby AlexNZ - Russia RepRap User Group