Show all posts by user
Page 1 of 1 Pages: 1
Results 1 — 7 of 7
שלום,
היום ההאקסלי שלי החליטה להתאבד, ואחרי כמה חודשים טובים של הדפסות, היא הוציאה עשן והמעבד של ה - Melzi נשרף. שמעתי שאפשר לקנות מעבד חדש ב- 8 דולר, אבל צריך מישהו שיודע לעשות SMD - סוג הלחמה מיוחד (surface mount solder) וגם לתכנת את השבב עצמו. מישהו יודע לעשות את זה? האופציה האחרת שלי היא לקנות את הלוח כולו מחדש בחמש מאות שקלים.... (אני מוכן לשלם למי שיצליח לתקן, כמובן).
by
sahar88888
-
Israel, Tel Aviv RepRap User Group
Dimensions are much better now ! thnx !
How do i get / use cura / slic3r and what is the best option?
and if i want to increase my resolution, what should i do?
by
sahar88888
-
General
OK ! I'll try it tomorrow. thnx ! I have another question meanwhile. I noticed my prints aren't filled correctly. What parameters should i change in skeinforge to make things filled? because on this page
it says i should change "fill width over thickness" and i can't find that setting anywhere !
by
sahar88888
-
General
So i should make 91.429 LESS until the cube's sides are even? (the Y axis is too short)
and btw the same thing happens on circles, there it's incredibly annoying.
by
sahar88888
-
General
I have a melzi board (the big green one) on a huxley machine, that's pretty much all i know, i'm gonna need a explanation about firmware types.. sorry for being so... ignorant XD
and maybe it's a problem with the belt or motor currents? when i check physically on the board there is about 0.005 (all between 0.39 and 0.41)
difference between the motor chip currents...
by
sahar88888
-
General
OK, but how do I change the number of motor steps in the firmware? Is it through the electrical board and the currents?
and thanks for answering that quickly
by
sahar88888
-
General
Hello, I am a fresh Huxley owner.
I tried to print a 1cm cube, and noticed the Y axis movement was too short- it was 9mm.
How do i make pronterface scale the Y axis? or is it impossible and I have to set the motor currents EXACTLY the same?
Also, I tried to set the "infill width over thickness" but failed to find it in pronterface settings (I am trying to set the printer using this : )
If you ca
by
sahar88888
-
General