Hello everyone, i built a plotter and i'm running marlin firmware on my arduino mega, but i'm not sure what are the modifications that i need to do in the configuration.h file to use a servo motor to move a pen up and down. Any thoughts? Thanks, AACby AAC - Firmware - Marlin
Hello, i know, a did that, but pronterface log says "Conecting...." forever. Do u think marlin is the best suited for plotter corexy?by AAC - CoreXY Machines
Hello, I created a coreXY plotter that i intent to control with an Arduino mega and a Ramps shield. Any sugestions and/or recommendations about the firmwares and compatible host interfaces that i should use? Note: I tried Marlin + pronterface but for no apparent reason pronterface cannot connect to my arduino mega. And it's kinda hard to understand where can i change parameters to add an servoby AAC - CoreXY Machines
Hello, I created a coreXY plotter that i intent to control with an Arduino mega and a Ramps shield. Any sugestions about the firmwares and compatible host interfaces that i should use? Note: I tried Marlin + pronterface but for no apparent reason pronterface cannot connect to my arduino mega. Thanks!by AAC - Let's design something! (I've got an idea ...)