Show all posts by user
p.s. RepRap.org isn't responsible for scams and bad deals.
Re: Mini differential IR height sensor board - 8 years ago
I wonder if any one can help please. I have been building a larger printer and have fitted a Mini differential IR height sensor. I an using a Radds controller. I have used a pair of volcano heads on a chimera block. Two weeks ago I had everything fitted and could home the 3 axis's. I could also do a G32 and all worked well. I have heated the hot ends but never put any filament in either of theby mjhall - For Sale
Re: Radds Help - 9 years ago
Again thanks I have ordered another Due. I checked the thermistor with a multi tester and the thermistor works on the old Geeetech board. The heaters are new as I want to use 24Volts so replaced them. I think i better check if they are shorting out when heated prior to fitting the new Due.by mjhall - General
Re: Radds Help - 9 years ago
So I should replace the Due as i have looked for shorts and couldn't find one? What could have caused this as i don't want to repeat it again. Thanks for the fast response.by mjhall - General
Radds Help - 9 years ago
I am new to radds and need some help. I an trying to fit it to a Delta. I had it fitted and axis moving, I intended to fit a Diamond hot end later so wanted the extra extruder ability. I heated up the standard Mk8 hot ends and printed a test cube. Modified the firmware and started a second print. three layers in the printer stopped. The hot end was reporting a temperature of 635C it had instantlyby mjhall - General