Show all posts by user
p.s. RepRap.org isn't responsible for scams and bad deals.
Re: Mini differential IR height sensor board - 8 years ago
That makes sense to me, either way, it's a good learning experience. Thanks again!by rtopz - For Sale
Re: Mini differential IR height sensor board - 8 years ago
Thanks for the info on the multimeter verification. I removed the connector after 2 hours of desoldering (I'm still a soldering freshman) as the multimeter testing of the VCC and Ground was failing. I then re-verified via the front and back holes on the board where the connector used to be. In the front, the multimeter was working fine and continuity was good. On the back holes however, the cby rtopz - For Sale
Re: Mini differential IR height sensor board - 8 years ago
Thanks for the quick reply, I didn't see it until now. Unfortunately, I don't see any led response at all. I will request the replacement. Btw, should there be any concern with heat issues on the board during soldering of the power connector? Should I be worried about it? I run around 600deg, enough to melt the solder.by rtopz - For Sale
Re: Mini differential IR height sensor board - 8 years ago
Hi, I bought one from filastruder and unfortunately, can't get it to work. The LED never lights up (connected correctly first time using 5V power from US. I was looking to replace my Z opto endstop with auto leveling. I checked the supplied cable with multimeter and that was okay. I verified my soldering of the connecter and that seemed okay. I checked z-min endstop voltage on my RAMPS 1.4by rtopz - For Sale