I built a custom Delta, combining both David Crockers delta design and a design I found at Norwegian Creations (https://www.norwegiancreations.com/). Anyways, my horizontals are 455mm, verticals 1000mm, rods are 400mm. The bed is 330mm with a printable area of ~310mm and maybe 430ish height. The entire bed fits within the confines of the Alu extrusions - except for the bulldog clips. I'm using aby electronlove - Delta Machines
3D Scanner interface electronics are currently available for the Raspberry Pi in a HAT format, for use with the FreeLSS software - if anyone is interested. eBay item #: 172729121100by electronlove - 3D Scanners, Book Scanners, and Optics
How long does a scan take on the Ciclop ? How many scans in total ? On FreeLSS, a high resolution scan (with the 5MP camera) with ~1600 scans can take ~40 min and requires cleanup in meshlab.by electronlove - 3D Scanners, Book Scanners, and Optics
With any of the DIY 3D scanners, calibration is critical otherwise it will not work well at all. I built a hybrid of the Atlas and Ciclop from what I found in forums and on Thingiverse ((PiClop) but had to make my own board for it. I liked some of the features of the Ciclop but did not want to have to run it from a PC. The Pi camera has the unfortunate problem that it is fixed-focus so you havby electronlove - 3D Scanners, Book Scanners, and Optics
I am currently printing PLA at 195C with an E3d v6 hotend, with 1.75 mm filament and 0.4 mm nozzle and slicing with the most recent version of Slic3r. What I have found is that after calibrating X,Y,Z, and the extruder, when I print either a calibration cube or nickel holder, the X,Y, and Z are quite good but the internal X and Y are off by at least 2%. After changing the extrusion multiplier tby electronlove - Slic3r
I actually had a quesiton regarding the board that you designed that is currently being sold through Pico. Is there a straightforward way to power the BBB from the CRAMPS board. I see that there is a 5V. Is that a 5V out on the board that can be used to directly power the BBB? Also, is the best approach for an LCD to use a breakout board like the one sold by Waveshare, the DVK530 ?by electronlove - Controllers
What is the best way to wire up the thermistor wire to the bed and give strain relief from the bed moving ? Also any sugggestion on the type of wire that works best for this ? Thanksby electronlove - Wanted
I am quite interested in a 32 bit solution for 3D printing. On the website, two RADDS boards are listed, RADDS Shield v1.1 - ohneSupport and InstallationsSupport. What is the exact difference between the two. Also, two power inputs are shown for the board, 1 for the heated bed and the other for everything else. Will I need to have two power supply or will a 12V 30A supply work ?by electronlove - Controllers