Show all posts by user
p.s. RepRap.org isn't responsible for scams and bad deals.
Re: Servo won't move with M280 GCode commands - 10 years ago
I had the same problem. Found that I had the wrong version of marlin board defined in configuration.h (I was using 1.3EFB - should have been using 1.4EFB. After changing to correct board, my servo works. Below is my configuration.h - for what its worth. Paul --- snip --- #include #ifndef CONFIGURATION_H #define CONFIGURATION_H #include "boards.h" #include "macros.h" //==================by PaulKoerber - Stepper Motors, Servo Motors, DC Motors
For sale - Makerfarm i3v-10 assembled (US only) - 10 years ago
Hello Reprappers, I am selling an assembled MakerFarm i3v-10 (v-slot - 10" bed) USA buyers only - sorry. I would prefer So. Cal - as I can deliver it, but willing to ship. Purchased just under a year ago, has not been used in 4 months. The unit works very well, but I need money for another project The unit is a stock unit w/ the following: - hexagon hotend - 1.75mm / .4mm nozzle - upgraded steby PaulKoerber - For Sale
Re: E3D V5 1.75 bowden wanted - 10 years ago
I have all metal E3D (type) hotheads - 1.75mm - I believe these are same specs as E3D v6 PM me if you want to discuss further Paulby PaulKoerber - Wanted
Re: First 3d Printer / Help - 10 years ago
2 of my printers are Chinese imports (Aurora a605) and they had aluminum heat plates. It used to take about 10 minutes to heat the bed (and I could only heat up to 75c). I replaced the aluminum heat plates with dual-coil PCB MK1 (12v) heat plates (there is a heating coil on the top and the bottom of the PCB - ebay find). I had to change the powersupply and add a relay - powersuply is a 410W ATXby PaulKoerber - General Mendel Topics
Re: aworldnet a600 won't extrude - 10 years ago
I believe the AWorldnet a600 uses a side-mounted stepper motor into a direct drive extruder (like a QU-BD). I have a couple of Aurora a605's that came like that. I don't care for them - I've replaced them with Gregs Wade extruder (and replaced the controller boards w/ RAMPS 1.4 units) - I found that I had to adjust the current on the RAMPS board and tighten the filament tension screw all the wayby PaulKoerber - General