Thanks. I figured that out by looking at the schematics.by Carsecond - General Mendel Topics
Hello - I have a RAMPS 1.4 and unfortunately my d8 is not working. How can I modify Marlin to allow me to use the d9 port as a replacement for the d8 port? Is this even possible, as in, will I even be able to heat up my heatbed in pronterface using the modification ? Thanks!by Carsecond - General Mendel Topics
I use RAMPS 1.4 and wired it according to this website: (which seems to work) I am using MARLIN firmware and have configured it exactly (EXACTLY!) according to this website: (I suppose I can post my config file if it helps.) My smooth rods are parallel, I was able to be very precise with these, however my threaded rods are a tad off (they lean inward) and although this may be the problem I hby Carsecond - General Mendel Topics
I am finishing my very first printer, a prusa i2. Everything works well, except for the z axis, which does not turn. I have adjusted the drivers and the steps/mm (I believe that's what it is called, its a speed setting in pronterface) and neither has worked. I know for a fact that the motors both work, and when I try to move the axis, they buzz - violently or softly, depends on the drivers' settiby Carsecond - General Mendel Topics
Hello - I am building a prusa i2 and I need an x carriage that will work with the fan on my all metal hotend, which will currently not fit under my x carriage. Is there anywhere I can purchase one that will surely fit the fan or would someone print one for me? I can pay hahaby Carsecond - Wanted
I am new here, so if this is in the wrong section of the forums, please kindly point me in the proper direction for this post and I will happily make it there. I recently purchased some rods and a belt for my Prusa i2 Project and my purchase came with a surprise: printed parts! I contacted the seller who revealed that he did not know if the parts were a complete set or what variant of the Prusaby Carsecond - General Mendel Topics