RUG/Pennsylvania/State College/Electronics/Extruder Tips
Revision as of 15:01, 11 October 2011 by Danielpublic (talk | contribs)
For using a PCPowerSupply as a PSU go here.
Phat #1
- Standard techzone kit
- 12.5 inch nichrome wire
- One thermocouple wrap around nichrome wire
- One thermocouple on top of other thermocouple
- Thermocouples: 2 wire
- PLA Operating Temp:
- Hours Operational:
MS #1
- Standard techzone kit
- 12.5 inch nichrome wire, Single Wrap Around Thermocouple
- Thermocouples:
- PLA Operating Temp:
- Hours Operational:
MS #2
- Standard techzone kit
- 12.5 inch nichrome wire, Thermocouple Nestled Against
- Thermocouples:
- PLA Operating Temp:
- Hours Operational:
Randy #1
- Standard techzone kit
- 12.5 inch nichrome wire, Single Wrap Around Thermocouple
- Thermocouples:
- PLA Operating Temp: ~190
- Hours Operational: 0
Randy #1
- Standard techzone kit
- 12.5 inch nichrome wire, No wraps Around Thermocouple
- Thermocouples:
- PLA Operating Temp:~200
- Hours Operational: 0
Future Tip Options
Materials to consider for future tips:
- Plastics
- Teflon (huxley had this, doesn't work great)
- PEEK
- Torlon
- Ceramic
- Metal?