SevenRap
Release status: Concept
Description | Low Cost, Post-Mendel Design
|
License | |
Author | |
Contributors | |
Based-on | [[]]
|
Categories | |
CAD Models | (none yet)
|
External Link | (none)
|
With it's "Sells" Mendel and Prusa Mendel design RepRap collected a lot of knowledge. It's about time to put this experience onto a white sheet of paper and do a new design from the ground up.
Another experience is with Generation 7 Electronics, which is designed to be as replicatable as possible and has slightly better specifications than other electronics. Still it wasn't widely accepted for this. The conclusion is, replicatability doesn't play a major role in the RepRap community and a new design should put more emphasis on low cost, than on printability.
Cost Estimate
Group | Cost |
---|---|
Electronics | $100 |
Steppers | $50 |
Wooden frame, wood screws | $20 |
Drawer sliders | $40 |
Belts, pulleys | $30 |
Extruder | $80 |
Miscellaneous | $30 |
Total | $350 |
As resolution, software, firmware and extruder is the same as that of a Mendel, there is no doubt this will print just as accurate as a Mendel.
That's it, for now. Let's fire up the CAD.