User:PilotDog
Clon: Irina 1.0
Prusa Iteración 3 Single Layer
HOJA DE RUTA:
- Marco y soporte de cama caliente en aluminio (Capi)
- 5 motores Nema 17.
- Kit que contiene lo siguiente:
1x Complete set of RAMPS 1.4 electronics:
- 1x Complete soldered RAMPS 1.4
- 5x A4988 Complete soldered G3D driver with additional CLK trimpot (this is much better than StepStick or Pololu due of selectable off-time)
- 1x Mega 2560
- 1x Complete soldered Sdramps extension
- 1x Cooler Fan
- 14 cables (complete wiring cables set):
- 6x 3 PIN cables for endstops
- 3x 2 PIN cables for thermistors
- 5x 4 PIN cables for motors
- 1x Japanese ceramic screwdriver
- 2x EPCOS 100k thermistor
1x LCD and SD card LCD/SD panel with RAMPS GADGETS3D Shield:
- 1x soldered and assembled panel with 4 rows LCD, SD card connector, ALPS rotary encoder.
- 1x soldered RAMPS GADGETS3D shield for easy connect panel into RAMPS 1.4.
- 1x Kingston 4GB SD card.
- 1x Plastic knob - 2x 10pin flat cable of 1 meter length.
- 2x 10pin flat cable of 35cm length.
1x RepRap Heatbed MK2a PCB
- 1x MK2a Heatbed PCB with LED's and resistor soldered
- 1x NTC EPCOS type 100K thermistor
- 1x Red and Black wires cable which can easily handle over 10A and save your time (special wires for handling high power)
1x Mechanical Endstops set
- 3x Mechanical Endstop (RepRap/Prusa/Huexley style)
1x G3D Buda-style pre-assembled Hotend
- Pre-assembled G3D Buda-style HotEnd
- 1x 0.4mm nozzle
- 1x 0.5mm nozzle
Me faltan las varillas y DONANTE de las piezas imprimibles.