Balancing ATX Supplies
Revision as of 20:34, 3 December 2011 by Bryanandaimee (talk | contribs)
A modern high power ATX supply off a PC is a good way to power your RepRap but requires a bit more care than a purpose built 12V supply. The main issue with these supplies is the requirement for a load on the 5V line. To get reliable opperation you will need to balance the loads on the 12V vs the 5V lines.
12 V Load | 5 V Load | 12 V Voltage | 5 V Voltage | ||||||
---|---|---|---|---|---|---|---|---|---|
2 | coupling | RP | |||||||
3 | endstop-holder | RP | 1 | x-carriage | RP | ||||
1 | x-end-idler | RP | |||||||
1 | x-end-motor | RP | |||||||
1 | y-motor-bracket | RP |