Talk:RepRapPro Tricolour extruder drive assembly

From RepRap
Revision as of 06:34, 6 April 2013 by Holgero (talk | contribs) (→‎BOM)
Jump to: navigation, search

Chapter Order

The chapter "Idler Tensioning" mentions two screws that are introduced only afterwards in the chapter "Fitting the drive". Perhaps this needs some re-ordering... --Holgero 08:34, 6 April 2013 (UTC)

BOM

I only needed 5 M3 nuts, did I miss something? Or where is the sixth M3 full nut supposed to go?

--Holgero 10:34, 6 April 2013 (UTC)

Retrieved from "https://reprap.org/mediawiki/index.php?title=Talk:RepRapPro_Tricolour_extruder_drive_assembly&oldid=88112"