All public logs
Combined display of all available logs of RepRap. You can narrow down the view by selecting a log type, the username (case-sensitive), or the affected page (also case-sensitive).
- 12:05, 5 December 2012 Roland (talk | contribs) uploaded File:Sprinter.zip (the sprinter firmware used by thereprapkitstore / James for his ABSPrusa in spring 2012)
- 14:03, 28 August 2012 Roland (talk | contribs) uploaded File:Stepper dissipator.JPG
- 13:50, 28 August 2012 Roland (talk | contribs) uploaded File:1024px-Sanguinololu12.png
- 17:27, 13 June 2012 Roland (talk | contribs) uploaded File:Cdtray side.jpg
- 17:21, 13 June 2012 Roland (talk | contribs) uploaded File:Robo reprap.jpg
- 17:10, 13 June 2012 Roland (talk | contribs) uploaded File:Absprusa finaly.jpg
- 17:02, 10 June 2012 Roland (talk | contribs) uploaded File:Absprusa - zy 6 leveling y-axis.jpg
- 16:34, 10 June 2012 Roland (talk | contribs) uploaded File:Absprusa - zy 7 final fit.jpg
- 16:34, 10 June 2012 Roland (talk | contribs) uploaded File:Absprusa - zy 5 ready to connect.jpg
- 16:33, 10 June 2012 Roland (talk | contribs) uploaded File:Absprusa - trick lighter.jpg
- 16:33, 10 June 2012 Roland (talk | contribs) uploaded File:Absprusa - zy 4 spring offset.jpg
- 16:33, 10 June 2012 Roland (talk | contribs) uploaded File:Absprusa - zy 3 m13 to m14.jpg
- 16:32, 10 June 2012 Roland (talk | contribs) uploaded File:Absprusa - zy 1 checking width.jpg
- 16:31, 10 June 2012 Roland (talk | contribs) uploaded File:Absprusa - zy 1 checking width zoom.jpg
- 18:30, 31 May 2012 Roland (talk | contribs) uploaded File:Absprusa - lengthening a belt.jpg (If you have been so stupid as to cut down the wrong belt for the y-axis, this is not the end of the world. Just lay the leftover from belt1 onto the end of belt 2 and tightly fix it with a sticky tape :-))
- 18:25, 31 May 2012 Roland (talk | contribs) uploaded a new version of File:Absprusa - installing the optional guide bearing.jpg
- 17:01, 31 May 2012 Roland (talk | contribs) uploaded File:Absprusa - installing the optional guide bearing.jpg ( There is no M4 16mm bolt in the kit to install the optional 624zz guide bearing, and it would be too short anyway. Just take the last 20mm bolt and insert it from the outside and secure it with the M4 nyloc nut from the inside :-))
- 02:42, 22 May 2012 User account Roland (talk | contribs) was created