User contributions
(newest | oldest) View (newer 50 | older 50) (20 | 50 | 100 | 250 | 500)
- 01:43, 11 April 2010 (diff | hist) . . (+356) . . N File:Waxuum6.jpg (Third attempt. This one worked well enough to test. Solidified wax forms a film on the inside of the case. This design uses a nested drain and vent. The cutting tip exits to the left in the picture. The vent exits to the right. An eight-ohm heater i) (current)
- 01:42, 11 April 2010 (diff | hist) . . (+459) . . N File:Waxuum3.jpg (Second attempt. Vent and drain tubes run in parallel, with a sort of notch at the tip to allow molten wax to be replaced with air from the vent, then moved up the drain tube into the case. Push-to-connect fitting (visible behind case) is used to connect) (current)
- 01:40, 11 April 2010 (diff | hist) . . (+436) . . N File:Waxuum1.jpg (First attempt. This is just a single-tube needle with a heater and thermistor. The air tube is stuck in place with caulk. The lid, heater, ports, etc are held in place with JB-weld. This design did not work at all because there was not sufficient heat) (current)
- 01:28, 11 April 2010 (diff | hist) . . (+5,725) . . Waxuum
- 16:56, 10 April 2010 (diff | hist) . . (+10) . . Waxuum
- 16:54, 10 April 2010 (diff | hist) . . (+17) . . N File:Waxuum case parts.zip (waxuum case parts) (current)
- 16:53, 10 April 2010 (diff | hist) . . (+16) . . N File:WaxVacuum3.jpg (wax vacuum image) (current)
- 16:48, 10 April 2010 (diff | hist) . . (+1,277) . . N Waxuum (Created page with '{{Development |name = Waxuum |status = Experimental |image = WaxVacuum3.jpg |description = A toolhead for making patterns from wax. |categories = [[:Category:Toolheads|Toolheads]…')
- 00:07, 6 April 2010 (diff | hist) . . (+6) . . N User talk:MattMoses (Created page with 'Hello.')
- 00:06, 6 April 2010 (diff | hist) . . (+3) . . N User:MattMoses (Created page with 'Hi.')
(newest | oldest) View (newer 50 | older 50) (20 | 50 | 100 | 250 | 500)