RUG/Pennsylvania/State College/Printers/PSU Big Red
'
Operating Specifications
Operating Specifications | |||||||
---|---|---|---|---|---|---|---|
Name | Status | Design | Electronics | Firmware | Extruder | Temperature | Comments |
Big Red | Still Being Assembled |
Photos
About this printer
This printer was printed and built by the following three indiviuals on the build team:
This printer is designed to be an Open Hybrid Mendel, or OHM for short.
We orignally hoped to print all piece in red, however due to the limited supply of red plastic we were forced to choose a different color. This particular class has been producing 3D printers from scratch. Most of the printers assembled are OHM printer models but each semester parts for the printers are being innovated and changed. For example, a few structual pieces for our printer have been tweaked to better accomadate the use of our printers. Also for our endstops we are transitioning from light sensors to touch sensors. Another change is we are changine the electronics system of our printers to the RAMPS electonics.
|