FoldaRap PG35L

From RepRap
Revision as of 17:38, 22 June 2013 by Emmanuel (talk | contribs)
Jump to: navigation, search

Back to the FoldaRap_Build_Manual

Don't forget to make a flat on the shaft if there isn't one, using a file
with a rubber roller
with a bearing and a bolt

PG35L.jpg x1 extruder motor (50cm) M3x12.jpg x2

FoldaRap extruder-idler2.jpg extruder-idler

(some early versions are using a rubber roller instead)

If your motor came with an aluminium gear, here is how I remove them (M4 bolt+hammer+vice) :




For the Pololu settings : 0.32 for the Vref