Hacks to the RepRap Motherboard v1.1
Revision as of 07:59, 19 June 2009 by 80.45.23.196 (talk) (New page: If you want to run this board off the USB cable without the big power connector do this: Image:front-small.jpg Put a link across two of the mounting holes for that connector (just to...)
If you want to run this board off the USB cable without the big power connector do this:
Put a link across two of the mounting holes for that connector (just to the left of A). Note - if you want access to the RS485 but don't want to use RJ45 connectors you'll find that simple 2.54mm pin headers fit neatly into the connections (see B).
Then put a link as shown at A above between the third pin of the USB TTL input (the red wire on the USB connector) and pin 2 of the ISP connector.
Your board will now be fully powered by the USB cable.