Pinch wheel variations

From RepRap
Revision as of 09:32, 16 March 2009 by (talk)
Jump to: navigation, search

This is the place to post variations on the pinch mechanism used by the [Thermoplast Extruder Version 2].

Knurling the motor's shaft


This is only difficult because it needs special equipment - a lathe and a [knurling tool]. Given those two, the task becomes quite easy.

Start by using a felt-tipped pen to mark 6mm along the shaft from the face of the motor; that is 6mm from the flat plane where the screw holes are, not from the raised boss in the center. This will be where the polymer filament will run.

Take the motor apart and removing the rotor. The rotor is intensely magnetic and will pick up any small pieces of steel from the vicinity, especially swarf in the lathe and elsewhere. So do this in clean conditions, or - when you reassemble the motor - some particles may get included and cause it to jam.

Leave the stepper motor's ball race on the end of the shaft that you are going to knurl - you won't be able to get it back on afterwards if you take it off. (I discovered this at the cost of one motor...)

Put the motor's long shaft in the lathe chuck by a few millimeters and tighten the chuck gently. Put a centre in the tailstock and use that to locate the other end of the shaft. Tighten the chuck firmly.

Set the lathe to its lowest speed.

With the lathe still stationary, put the knurling tool in the tool post and line it up with the shaft. Make sure your pen mark is within the section that will be knurled, though it doesn't have to be dead centre.

Open the gap in the knurling tool wider than the shaft.

Use the cross slide to move the tool so that it pincers the shaft. Try to get it as central as possible - that is, get it so that each knuring wheel is pinching across a diameter of the shaft and is not offset. Tighten the knurling tool finger tight.

Check that nothing will foul as the lathe rotates by turning the chuck by hand.

Turn the lathe on. Gradually tighten the knurling tool (this will probably need a spanner).

You can stop the lathe in mid-knurl to see how things are going. When you do this, leave the knurling tool in place.

You want to end up with a knurl that is even and about 0.5mm deep.

When you have finished take the rotor out of the lathe and inspect it carefully for small magnetic particles attached to it. Remove any you find.

Put the stepper back together.

Putting a knurled sleeve on the shaft

Putting a small gear wheel on the shaft