RUG/Pennsylvania/State College/Printers/PSU [email protected]

From RepRap
Revision as of 23:32, 26 April 2011 by Php5014 (talk | contribs) (Progress)
Jump to: navigation, search


PSU [email protected] is in operational mode and continue to be in diagnostic form.

Build Notes

The [email protected] were completed mechanically by previous owner of the machine. I did check every part to make sure that were properly align and secure. Using the wiki *[] as a guide, the [email protected] were mechanically build as instructed.

Electronic Kits=

Microcontroller Olimex Philip LPC-H2148 *[1] Apparently, we are missing the JTAG cord which is important for flashing the microcontroller. I believe we are specifically looking for OpenOCD with firmware v4. However, the board were flash for firmware v3. Reference: *[}


Currently we have Acrylic Winsor Blue available for part to print. More to come on order and check out vendors for harware and material:

Diagnostic Notes

Currently, [email protected] machine has a working X axis and Z axis. Y axis does not function very well because there is something wrong with the motor not being adjusted. Also, the X axis seem to be driven itself after the program are close, which is not good. With in this week, we can expected to get the [email protected] ready for future project.


[email protected] homepage: *[2]