RUG/Pennsylvania/State College/Printers/PSU Unit Gold
Revision as of 01:53, 5 December 2013 by Dgdwazzaaa (talk | contribs) (Table colors are now consistent.)
|
|
This page contains information about the PSU Unit Gold 3D printer.
Contents
Current Team
Ian Beavers, Patrick Mangan, Austin Tokarz, Hamed Lashkari
Log
| Date | Modification / Problem |
|---|---|
| 09/04/2013 | The printer needs an extruder |
| 09/10/2013 | Extruder frame mostly assembled, end stops obtained and attached to mounts, arduino w/ driver obtained.
Next steps: Print large extruder gear, assemble and attach extruder, attach and wire endstops, attach and wire arduino. Also note: We need to add a bearing to the extruder and switch the carriage sides. |
Operating Specifications
| Design | Ohm |
| Electronics | RAMPS 1.4 |
| Firmware | |
| Extruder | 0.35mm |
Modifications & Upgrades
- Quick-leveling Bed Thumbwheels
- Maximized Print Bed
- Spool Holder
