RUG/Pennsylvania/State College/Printers/PSU Unit Silver
Revision as of 01:42, 28 April 2013 by Blacklaser (talk | contribs)
This page is for information about the PSU Unit Silver, which is fully operational. In order to make the noise lower,put some heavy stuff on the -Y half bed.
Operating Specifications
| Operating Specifications | |||||||
|---|---|---|---|---|---|---|---|
| Name | Status | Design | Electronics | Firmware | Extruder | Temperature | Comments |
Silver 
|
Working | Ohm | RAMPS | [RAMPS v1.4] | 0.5mm tip | 205C | None. |
Changes need to be made in order to get better prints
Silver is a printer good at printing square blocks. The print speed of Silver is very fast. However, due to the bad quality of Open-X carriage(warping), Silver right now cannot print perfectly circular parts. The open-x carriage can be replaced to increase print quality. Also, a Fan is mounted on the frame of Silver, but not connected.
The right open-Y carriage arm was damaged and repaired with super glue. However, the problem remains and that part needs to be replaced.
| ||||||||||
