White
Color:	White
Extruder:	?
Temperature:	220C

This page is for information about the PSU Unit White (Ψ). This unit is of the Mendel/Prusia hybrid variety. All of the printed parts were printed by other units in our group.

Log

Date	Modification / Problem
09/03/2013	X-Axis pulleys must be changed

Operating Specifications

Design	Ohm
Electronics	RAMBO 1.4
Firmware
Extruder
Heated Bed

PSU Unit White - Current Condition

As of 9/15/11
As of 11/15/11
Spring 2012

Print Problems And Solutions

PROBLEM	SOLUTION
Prints were leaning to one side.	Reattached the Y-axis pulley securely.
Motors were getting very hot.	Adjusted the potentiometers so the motors had just enough power to drive the axis and run the extruder.
Tip temp. read '2511' in Repsnapper.	Reconnected thermocouple more securely.
Extruder motor gear slipping.	Super-glued gear to motor shaft.
The extruder bolt was mis-alinged so the filament was not feeding.	Adjusted the spacing of the extruder bolt with washers.