User contributions
(newest | oldest) View (newer 20 | older 20) (20 | 50 | 100 | 250 | 500)
- 06:57, 27 April 2016 (diff | hist) . . (+125) . . Using PT100 temperature sensors with the Duet and RepRapFirmware (→Wiring)
- 05:30, 27 April 2016 (diff | hist) . . (+70) . . RepRap Firmware (→See also)
- 05:29, 27 April 2016 (diff | hist) . . (+295) . . RepRap Firmware (→Compiling from Source)
- 05:24, 27 April 2016 (diff | hist) . . (+2,601) . . N Using PT100 temperature sensors with the Duet and RepRapFirmware (Created page with "This page describes the support for PT100 and other RTD temperature sensors in RepRapFirmware version 1.12-dc42 and later with Duet electronics. =Hardware= To connect a PT10...")
- 04:59, 27 April 2016 (diff | hist) . . (+248) . . Configuring RepRapFirmware for a Cartesian printer (→Heater and thermistor section)
- 08:26, 21 April 2016 (diff | hist) . . (+37) . . m G-code (→M207: Set retract length)
- 05:37, 21 April 2016 (diff | hist) . . (+75) . . G-code (→M350: Set microstepping mode)
- 09:23, 19 April 2016 (diff | hist) . . (0) . . Using thermocouples with the Duet and RepRapFirmware (→Wiring)
- 07:24, 9 April 2016 (diff | hist) . . (-7) . . G-code (→M207: Set retract length)
- 07:22, 9 April 2016 (diff | hist) . . (+29) . . G-code (→G11: Unretract)
- 07:21, 9 April 2016 (diff | hist) . . (+16) . . G-code (→G10: Retract)
- 07:19, 9 April 2016 (diff | hist) . . (+173) . . G-code (→G10: Retract)
- 13:01, 1 April 2016 (diff | hist) . . (+2) . . m G-code (→M350: Set microstepping mode)
- 13:01, 1 April 2016 (diff | hist) . . (-21) . . G-code (→M350: Set microstepping mode)
- 03:49, 24 March 2016 (diff | hist) . . (+148) . . G-code (→M572: Set or report extruder elasticity compensation)
- 11:21, 22 March 2016 (diff | hist) . . (+29) . . G-code (→M600: Filament change pause)
- 08:01, 22 March 2016 (diff | hist) . . (+221) . . G-code (→M581: Configure external trigger)
- 07:48, 22 March 2016 (diff | hist) . . (-230) . . G-code (→M582: Check external trigger)
- 07:38, 22 March 2016 (diff | hist) . . (+99) . . G-code (→M581: Configure external trigger)
- 07:35, 22 March 2016 (diff | hist) . . (+869) . . G-code (→M582: Check external trigger)
(newest | oldest) View (newer 20 | older 20) (20 | 50 | 100 | 250 | 500)