File list
This special page shows all uploaded files.
Date | Name | Thumbnail | Size | Description | Versions |
---|---|---|---|---|---|
01:43, 11 April 2010 | Waxuum6.jpg (file) | 113 KB | Third attempt. This one worked well enough to test. Solidified wax forms a film on the inside of the case. This design uses a nested drain and vent. The cutting tip exits to the left in the picture. The vent exits to the right. An eight-ohm heater i | 1 | |
01:42, 11 April 2010 | Waxuum3.jpg (file) | 90 KB | Second attempt. Vent and drain tubes run in parallel, with a sort of notch at the tip to allow molten wax to be replaced with air from the vent, then moved up the drain tube into the case. Push-to-connect fitting (visible behind case) is used to connect | 1 | |
01:40, 11 April 2010 | Waxuum1.jpg (file) | 78 KB | First attempt. This is just a single-tube needle with a heater and thermistor. The air tube is stuck in place with caulk. The lid, heater, ports, etc are held in place with JB-weld. This design did not work at all because there was not sufficient heat | 1 | |
16:54, 10 April 2010 | Waxuum case parts.zip (file) | 80 KB | waxuum case parts | 1 | |
16:53, 10 April 2010 | WaxVacuum3.jpg (file) | 74 KB | wax vacuum image | 1 |