Talk:Choosing Belts and Pulleys

From RepRap
Revision as of 08:00, 7 March 2012 by Bitflusher (talk | contribs) (Created page with 'From the article: ''Unfortunately, with the exception of the hot end and extruder, the pulleys and belts are '''probably the single most important parts when it comes to improvin…')
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

From the article: Unfortunately, with the exception of the hot end and extruder, the pulleys and belts are probably the single most important parts when it comes to improving your print quality, and the commonly used parts are almost completely wrong for what we do.

When there are two more important parts it is obviously not the single most importand boldfaced part. I personally think people with bad print quality can gain alot by spending time on calibration, creating a tighter/more rigid frame and choosing the right plastic supplier.

The article doesn't show any evidence of converted setups with before/after pictures. about the less noise claim no youtube video's exist with a comparison. For this the right firmware software combination is also an essential part.

When it comes to improvement of quality from decent to great quality I do think it is an obvious path to choose. Bitflusher 12:00, 7 March 2012 (UTC)